Patio doors could really give new life to a dull area. If you have a room in your home that is just too dark, complete glass doors can let in a lot of light and also change the whole setting, making it an even more enjoyable location to be. Furthermore, the doors will certainly provide you visibility so you could see what’s happening outside, something that is specifically beneficial if you have toddlers that play outdoors.
Installing your very own patio doors is an excellent way to save money as well as truly isn’t really that tough. Just see to it you gauge very carefully prior to you start as well as you shouldn’t have any kind of troubles.
Mark an Area
Initially, make a decision where the door will certainly go. This could be taking over a room formerly occupied by a routine door, or simply an area of wall surface. Mark the measurements on the wall so you can see exactly what you’re doing and afterwards check that there are no pipes, tubes or electrical wires running through that section of wall surface. When you gauge, leave an additional four inches on each side for studs and seven inches at the top for a header.
15 photos of the How to Install Patio Doors
Electric cables can be relocated, but home heating or water pipes will be much more tough. Instead of tinker them, you would certainly be far better off searching for a section of wall that does not have anything inside, ideally.
Tear It Down
Chip away the wall very carefully inside the location that you have actually noted. Make certain to get rid of all insulation and also anything else you locate in the wall.
Break throughout the wall surface to the outside as well as take it all out, leaving the studs standing. The studs need to be gotten rid of with like keep the wall supported.
Taking Out the Studs
Brace the wall before getting rid of the existing studs. You’ll need to cut them at the top and after that pry them loose at the bottom. These could generally be recycled in another task, so keep them about.
Currently you’ll have to build a brand-new structure. The brand-new structure will include sturdy studs on either side of the opening and also a new header. Make the new header from 2x6s nailed together with a spacer item of wood in the middle. The spacer has to be big sufficient making the header the very same size as the wall surface. Safeguard every little thing effectively making use of screws (nails have the tendency to shake loose in time) and also make certain that it is quite durable.
Install the Door
The patio door need to come prepared to get on area. Put screws in the given holes as well as protect the door in place. You can currently caulk around the side and plaster the wall surface to produce a good looking finish. Once it remains in place, painting any kind of revealed areas. You should currently have a brand-new patio door, nicely installed and prepared to use!